Aluminum Spindle, V2 Incline: 8X

It is recomended that these are run with V2 Spindle carriers (TLR344056, TLR344051)

They can be used with older spindle carriers but you will need to remove some material from the carrier for drive shaft clearance depending on your spindle height settings.    

If these are fitting these to a non 2.0 you will need to change the ackerman arm to accomadate the m3 screws, vs the m2.5 on the earlier 8ight X

Running these spindles will narrow the front track width, this can be countered going out .5 in the front pills (8ight X 2.0 only)